BRP E-TEC EVINRUDE Manual page 313

Fill the oil reservoir up to the fill plug with the cor-
rect fluid. Install the fill plug.
2-Cylinder Models
1. Fill location
1
3-Cylinder Models – Use only Evinrude/Johnson
Biodegradable TNT Fluid
1. Fill location
Clean up any spilled hydraulic fluid with shop tow-
els.
ENVIRONMENTAL NOTE
Dispose of spilled hydraulic fluid or contaminated
towels in an environmentally responsible manner,
or according to local regulations.
Run the motor, then recheck oil level. Cycle the
unit several times and check the oil level when the
cylinder is fully extended. Oil should be level with
bottom of fill port. Install and tighten the fill plug to
a torque of 45 to 55 in. lbs. (5 to 6 N·m).
Refer to Installation on p. 301 for trim and tilt
assembly installation procedure.
1
007646
004278
Trim and Tilt
Trim and Tilt Service
313
12