BRP E-TEC EVINRUDE Manual page 312

Trim and Tilt
Trim and Tilt Service
Removal
Remove the four large motor flange retaining
screws. Remove the motor and discard O-ring,
screws, and washers.
2-Cylinder Models
3-Cylinder Models
Remove drive coupler from either the motor or the
pump assembly.
312
Installation
IMPORTANT – 3-Cylinder models:
Evinrude/Johnson Biodegradable TNT Fluid to fill
the hydraulic system.
Install drive coupler in pump assembly.
Install a new motor O-ring.
002531
Position the motor on the manifold and install four
new screws and lock washers. Tighten the screws
35 to 50 in. lbs. (4 to 5.6 N·m).
004282
2-Cylinder Models
002532
3-Cylinder Models
Use only
002533
002531
004282