BRP E-TEC EVINRUDE Manual page 300

Trim and Tilt
Trim and Tilt Replacement
Separate the trim/tilt unit wires in the braided tube
to permit removal through the hole in the stern
bracket.
2-Cylinder Models
Remove the spring clip from the cylinder pin.
Thread Adapter, P/N 340624, onto Slide Hammer,
P/N 391008. Screw the adapter into the cylinder
pin and remove the pin.
3
1. Thread adapter
2. Slide hammer
3. Cylinder pin
300
25078
15493
1
2
39434
Remove one of the locknuts from the angle adjust-
ment rod. Remove the rod from the stern brack-
ets.
Remove the unit from the stern brackets far
enough to remove the ground lead from the pump
motor mounting screw.
1. Ground lead
3-Cylinder Models
Remove the external snap rings from the upper
pin.
18941
1
007640
25064