BRP E-TEC EVINRUDE Manual page 154

Fuel System
Fuel Component Servicing
Turn the puller nut until the fuel injector is
removed from the fuel injector housing.
1. Fuel injector removed from fuel injector housing
Remove fuel injector puller from injector. Remove
crush ring and O-rings from injector. Inspect and
clean injector filter. Install new crush ring and O-
rings. Lubricate O-rings with STP
1. Crush ring
2. O-rings
Install injector into mount housing. Press on injec-
tor face until injector seats in mount housing.
154
Installation
All injectors must be installed in the correct
cylinder by serial number. Improper injector
installation can result in powerhead failure.
Installation of a replacement injector requires that
coefficient data for the new injector is uploaded to
1
the EMM.
Coefficient data for some replacement injectors is
supplied on a computer disk shipped with the
injector. If a disk is not included with the injector,
008799
coefficient data can be downloaded from the Evin-
rude/Johnson dealer website. Refer to the instruc-
tions provided with the injector kit.
Upload Coefficient Files to EMM
†
Oil Treatment.
IMPORTANT:
Tool, P/N 587005, to supply power to the EMM,
2
use Accessory Power Cable Kit, P/N 5008092, to
connect an external 12 volt battery to the Power
2 Supply Tool.
If the internal batteries of the Power Supply Tool
1
have a low voltage condition the EMM could turn
OFF during the coefficient upload, resulting in a
failed update.
Use the Evinrude Diagnostics software Settings
screen to upload the coefficient file to the EMM.
002317
Select the Injectors tab.
Select the cylinder tab for injector being replaced.
002318
NOTICE
If using Diagnostic Power Supply