BRP E-TEC EVINRUDE Manual page 266

Midsection
Stern Bracket, 2-Cylinder Manual Tilt
Slide the pivot shaft and upper thrust washer out
of the swivel bracket.
1. Upper thrust washer
Use an appropriate tool to pry the upper and lower
seals from the swivel bracket.
Loosen the steering friction screw while pushing
outward on the steering friction pin. When the pin
266
1
COA2956
COA2957
COA2958
is flush with the inside surface of the casting,
remove the steering friction thrust ring.
1. Steering friction screw
1. Steering friction pin
2. Steering friction thrust ring
Tighten the steering friction screw until the steer-
ing friction pin can be removed. Then, remove the
steering friction screw.
Remove the two setscrews from the swivel
bracket.
1. Setscrews
1
COA2959
1
2
COA2988
1
1
COA2961