BRP E-TEC EVINRUDE Manual page 306

Trim and Tilt
Trim and Tilt Service
Use end cap spanner wrench, P/N 352932, to
remove the end cap from the trim and tilt assem-
bly.
1. End cap spanner wrench
Remove the rod, piston and end cap assembly
from the cylinder of the trim and tilt assembly.
Drain remaining trim and tilt fluid from the cylinder
of the trim and tilt assembly.
Clean up any spilled hydraulic fluid with shop tow-
els.
ENVIRONMENTAL NOTE
Dispose of spilled hydraulic fluid or contaminated
towels in an environmentally responsible manner,
or according to local regulations.
Use hydraulic cylinder rod holder set, P/N 983213
to hold the rod in a vice as shown.
Remove fastener and washer from piston assem-
bly.
306
1
008817
Note: Use spanner wrench, P/N T-552, to remove
fastener from piston of trim and tilt assembly,
P/N 5005756.
1. Hydraulic cylinder rod holder set
2. Fastener
3. Washer
Remove springs, valves and check balls from the
piston assembly.
1. Springs, valves and check balls
Remove seal and o-ring from the piston.
1. Seal
2. O-ring
Remove the piston from the rod.
2
3
1
008818
1
008819
1
2
008820