BRP E-TEC EVINRUDE Manual page 308

Trim and Tilt
Trim and Tilt Service
Apply red Ultra Lock to the threaded portion of the
rod, piston and fasteners. Install the piston on the
rod.
Use piston spanner wrench, P/N T-553, to install
piston on the rod of trim and tilt assembly,
P/N 5007776. Tighten piston to specified torque,
refer to Service Charts on p. 292.
1
1. Piston spanner wrench
Assemble the piston as shown in the Service
Charts on p. 292.
308
Tighten fasteners to specified torque, Service
Charts on p. 292.
008826
Apply trim/tilt fluid to the inside diameter of the
resizing fixture. Place the resizing fixture over the
piston with the tapered end up. Slide the resizing
fixture down past the piston.
1. Resizing fixture
008827
Not all hydraulic assemblies use the same shim
for assembly. Select the appropriate shim from the
008828
1
008829