set boot system
Syntax
show boot system
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the switch's boot firmware image:
G3(su)->show boot system
Current system image to boot: bootfile
set boot system
Use this command to set the firmware image the switch loads at startup.
Syntax
set boot system filename
Parameters
filename
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the boot firmware image file to "newimage":
G3(su)->set boot system newimage
2-38 Basic Configuration
Specifies the name of the firmware image file.