Commands; Show Port Speed; Set Port Speed - Enterasys G3G170-24 Cli Reference Manual

show port speed

Commands

For information about...
show port speed

set port speed

show port duplex
set port duplex
show port speed
Use this command to display the default speed setting on one or more ports.
Syntax
show port speed [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, default speed settings for all ports will display.
Mode
Switch command, read‐only.
Example
This example shows how to display the default speed setting for 1‐Gigabit Ethernet port 14 in
slot 3:
G3(su)->show port speed ge.3.14
default speed is 10 on port ge.3.14.
set port speed
Use this command to set the default speed of one or more ports. This setting only takes effect on
ports that have auto‐negotiation disabled.
Syntax
set port speed port-string {10 | 100 | 1000}
Parameters
port‐string
4-10 Port Configuration
(Optional) Displays default speed setting(s) for specific port(s). For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐1.
Specifies the port(s) for which to a speed value will be set. For a
detailed description of possible port‐string values, refer to "Port
String Syntax Used in the CLI" on page 4‐1.
Refer to page...
4-10
4-10
4-11
4-14