Clear Ip Address; Show Ip Protocol - Enterasys G3G170-24 Cli Reference Manual

clear ip address

mask ip‐mask
gateway ip‐gateway
Defaults
If not specified, ip‐mask will be set to the natural mask of the ip‐address and ip‐gateway will be set to
the ip‐address.
Mode
Switch command, read‐write.
Usage
Paramters must be entered in the order shown (host IP, then mask, then gateway) for the
command to be accepted.
Example
This example shows how to set the system IP address to
G3(su)->set ip address 10.1.10.1 mask 255.255.128.0
clear ip address
Use this command to clear the system IP address.
Syntax
clear ip address
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the system IP address:
G3(rw)->clear ip address

show ip protocol

Use this command to display the method used to acquire a network IP address for switch
management.
Syntax
show ip protocol
2-10 Basic Configuration
(Optional) Sets the system's subnet mask.
(Optional) Sets the system's default gateway (next‐hop device).
10.1.10.1 with a mask of 255.255.128.0: