set webview
Mode
Switch command, read‐only.
Example
This example shows how to display WebView status:
G3(rw)->show webview
WebView is Enabled.
set webview
Use this command to enable or disable WebView on the switch.
Syntax
set webview {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Usage
It is good practice for security reasons to disable HTTP access on the switch when finished
configuring with WebView, and then to only enable WebView on the switch when changes need
to be made.
Example
This example shows how to disable WebView on the switch:
G3(rw)->set webview disable
show ssl
Use this command to display SSL status.
Syntax
show ssl
Parameters
None.
Defaults
None.
2-54 Basic Configuration
Enable or disable WebView on the switch.