Show Ipv6 Ospf Output Details - Enterasys G3G170-24 Cli Reference Manual

show ipv6 ospf
Defaults
None.
Mode
Router privileged execution: G3(su)‐>router#
Example
This example shows how to display OSPFv3 router information.
G3(su)->router# show ipv6 ospf
Router ID
OSPF Admin Mode
ASBR Mode
ABR Status
Exit Overflow Interval
External LSA Count
External LSA Checksum
New LSAs Originated
LSAs Received
External LSDB Limit
Default Metric
Maximum Paths
Default Route Advertise
Always
Metric
Metric Type
Table 19‐1 provides an explanation of the command output.
Table 19-1 show ipv6 ospf Output Details
Output Field
Router ID
OSPF Admin Mode
ASBR Mode
ABR Status
Exit Overflow Interval
External LSA Count
External LSA Checksum
19-28 OSPFv3 Configuration
Note: Some of the information in
certain features.
2.2.2.2
Enable
Enable
Enable
0
0
0
89
177
No Limit
Not Configured
4
Disabled
FALSE
External Type 2
Table 19-1 displays only if you enable OSPFv3 and configure
What It Displays...
A 32 bit integer in dotted decimal format identifying the router,
about which information is displayed. This is a configured value.
Whether the administrative mode of OSPF in the router is enabled
or disabled. This is a configured value.
Whether the ASBR mode is enabled or disabled. Enable implies
that the router is an autonomous system border router. Router
automatically becomes an ASBR when it is configured to
redistribute routes learnt from other protocol. The possible values
for the ASBR status is enabled (if the router is configured to re-
distribute routes learnt by other protocols) or disabled (if the router
is not configured for the same).
Whether the router is an OSPF Area Border Router.
The number of seconds that, after entering Overflow State, a
router will attempt to leave Overflow State.
The number of external (LS type 5) link-state advertisements in
the link-state database.
The sum of the LS checksums of external link-state
advertisements contained in the link-state database.