Set Igmpsnooping Maxresponse - Enterasys G3G170-24 Cli Reference Manual

Hide thumbs Also See for G3G170-24:

Table of Contents

Switch command, read‐write.

The IGMP group membership interval time sets the frequency of host‐query frame transmissions

and must be greater than the IGMP maximum response time as described in "set igmpsnooping

maxresponse" on page 10‐5.

This example shows how to set the IGMP group membership interval to 250 seconds:

G3(su)->set igmpsnooping groupmembershipinterval 250

set igmpsnooping maxresponse

Use this command to configure the IGMP query maximum response time for the system.

set igmpsnooping maxresponse time

Switch command, read‐write.

This value must be less than the IGMP maximum response time described in "set igmpsnooping

groupmembershipinterval" on page 10‐4.

This example shows how to set the IGMP maximum response time to 100 seconds:

G3(su)->set igmpsnooping maxresponse 100

Specifies the IGMP maximum query response time. Valid values are 100 ‐

255 seconds. The default value is 100 seconds.

This value works together with the set igmpsnooping

groupmembershipinterval command to remove ports from an IGMP group

and must be lesser than the group membership interval value.

set igmpsnooping maxresponse

Enterasys G-Series CLI Reference 10-5