Interface Configuration Commands
Example
This example sets the transmit delay to 2 seconds for the specified OSPFv3 virtual interface.
G3(su)->router(Config-router)# area 20 virtual-link 2.2.2.2 transmit-delay 2
Interface Configuration Commands
Purpose
These commands can be used to configure OSPF v3 routing interface parameters.
Commands
For information about...
ipv6 ospf enable
ipv6 ospf areaid
ipv6 ospf cost
ipv6 ospf dead-interval
ipv6 ospf hello-interval
ipv6 ospf mtu-ignore
ipv6 ospf network
ipv6 ospf priority
ipv6 ospf retransmit-interval
ipv6 ospf transmit-delay
ipv6 ospf enable
This command enables OSPFv3 on a router interface or a loopback interface.
Syntax
ipv6 ospf enable
no ipv6 ospf enable
Parameters
None.
Defaults
OSPFv3 is disabled by default.
Mode
Router interface configuration: G3(su)‐>router(Config‐if(Vlan 1))#
19-20 OSPFv3 Configuration
Refer to page...
19-20
19-21
19-22
19-22
19-23
19-24
19-24
19-25
19-26
19-26