Enterasys G3G170-24 Cli Reference Manual page 154

show linkflap
totalcount
timelapsed
violations
port‐string
Defaults
• If not specified, information about all link flap detection settings will be displayed.
• If port‐string is not specified, information for all ports will be displayed.
Mode
Switch mode, read‐only.
Usage
The linkflap default conditions are shown in the following table.
Linkflap Parameter
Linkflap global state
Linkflap port state
Linkflap action
Linkflap interval
Linkflap maximum allowed link downs per 10 seconds
Linkflap threshold
(number of allowed link down transitions before action is taken)
Examples
This example shows how to display the global status of the link trap detection function:
G3(rw)->show linkflap globalstate
Linkflap feature globally disabled
This example shows how to display ports disabled by link flap detection due to a violation:
G3(rw)->show linkflap downports
Ports currently held DOWN for Linkflap violations:
None.
This example shows how to display the link flap parameters table:
G3(rw)->show linkflap parameters
Linkflap Port Settable Parameter Table (X means error occurred)
Port
--------
ge.1.1
ge.1.2
ge.1.3
Table 4‐3 provides an explanation of the show linkflap parameters command output.
4-22 Port Configuration
Displays how many linkdown transitions have occurred since the last
reset.
Displays the time period since the last link down event or reset.
Displays the number of link flap violations since the last reset.
(Optional) Displays information for specific port(s).
LF Status Actions
--------- -------
disabled .......
enabled D..S..T
disabled ...S..T
Threshold Interval
---------- ----------
10 5
3 5
10 5
Default Condition
Disabled
Disabled
None
5
20
10
Downtime
----------
300
300
300