Show Cos Settings; Set Cos Port-Config - Enterasys G3G170-24 Cli Reference Manual

show cos settings

Use this command to display Class of Service parameters.
Syntax
show cos settings [cos-list]
Parameters
cos‐list
Defaults
If not specified, all CoS entries will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to show all CoS settings:
G3(su)->show cos settings
CoS Index Priority
--------- ---------- ------- -----
0
1
2
3
4
5
6
7

set cos port-config

Use this command to create a port group for inbound rate limiting and add or remove ports from
the group.
Syntax
set cos port-config irl group-type-index [name name] [ports port-list] [append] |
[clear]
Parameters
irl
group‐type‐index
name name
(Optional) Specifies a Class of Service entry to display.
ToS IRL
0 * *
1 * *
2 * *
3 * *
4 * *
5 * *
6 * *
7 * *
Specifies that this is an inbound rate limiting (IRL) port group.
Specifies an inbound rate limiting port group/type index. Valid entries
are in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
(Optional) User defined name for the group.
show cos settings
Enterasys G-Series CLI Reference 8-21