Set Spantree Portpri - Enterasys G3G170-24 Cli Reference Manual

set spantree portpri

Parameters
port port‐string
sid sid
Defaults
If port‐string is not specified, port priority will be displayed for all Spanning Tree ports.
If sid is not specified, port priority will be displayed for Spanning Tree 0.
Mode
Switch command, read‐only.
Example
This example shows how to display the port priority for
G3(su)->show spantree portpri port ge.2.7
Port ge.2.7 has a Port Priority of 128 on SID 0
set spantree portpri
Use this command to set a port's Spanning Tree priority.
Syntax
set spantree portpri port-string priority [sid sid]
Parameters
port‐string
priority
sid sid
Defaults
If sid is not specified, port priority will be set for Spanning Tree 0.
Mode
Switch command, read‐write.
Example
This example shows how to set the priority of
G3(su)->set spantree portpri ge.1.3 240 sid 1
6-34 Spanning Tree Configuration
(Optional) Specifies the port(s) for which to display Spanning Tree priority.
For a detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐1.
(Optional) Displays port priority for a specific Spanning Tree identifier.
Valid values are 0 ‐ 4094. If not specified, SID 0 is assumed.
Specifies the port(s) for which to set Spanning Tree port priority. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐1.
Specifies a number that represents the priority of a link in a Spanning Tree
bridge. Valid values are from 0 to 240 (in increments of 16) with 0
indicating high priority.
(Optional) Sets port priority for a specific Spanning Tree identifier. Valid
values are 0 ‐ 4094. If not specified, SID 0 is assumed.
ge
.2.7:
ge
.1.3 to 240 on SID 1