ipv6 unicast-routing
Usage
The default distance is used when no distance is specified in the ipv6 route command. Changing
the default distance does not update the distance of existing static routes, even if they were
assigned the original default distance. The new default distance will only be applied to static
routes created after invoking the ipv6 route distance command.
Use the no form of this command to return the default distance to 1.
Example
This command sets the default distance value to 3.
G3(su)->router(Config)# ipv6 route distance 3
ipv6 unicast-routing
This command enables/disables forwarding of IPv6 unicast datagrams.
Syntax
ipv6 unicast-routing
no ipv6 unicast-routing
Parameters
None.
Defaults
Disabled.
Mode
Router global configuration: G3(su)‐>router(Config)#
Usage
Use this command to enable forwarding of IPv6 unicast datagrams on the Enterasys G‐Series. Use
the no form of the command to disable forwarding of IPv6 unicast datagrams.
Example
This command enables forwarding of IPv6 unicast datagrams on the router.
G3(su)->router(Config)# ipv6 unicast-routing
ping ipv6
Use this command to test routing network connectivity by sending IP ping requests.
Syntax
ping ipv6 ipv6-addr [size num]
Parameters
ipv6‐addr
18-6 IPv6 Configuration
Specifies the global IPv6 address of the system to ping. Enter the address in
the form documented in RFC 4291, with the address specified in
hexadecimal using 16‐bit values between colons.