Ip Rip Send Version - Enterasys G3G170-24 Cli Reference Manual

ip rip send version

Usage
If several routes (coming from different protocols) are presented to the G‐Series, the protocol with
the lowest administrative distance will be chosen for route installation. By default, RIP
administrative distance is set to 120. The distance command can be used to change this value,
resetting RIP's route preference in relation to other routes as shown in the table below.
Route Source
Connected
Static
OSPF
RIP
Example
This example shows how to change the default administrative distance for RIP to 1001:
G3(su)->router(Config)#router rip
G3(su)->router(Config-router)#distance 100
ip rip send version
Use this command to set the RIP version for RIP update packets transmitted out an interface. The
no version of this command sets the version of the RIP update packets to RIPv1.
Syntax
ip rip send version {1 | 2 | r1compatible}
no ip rip send version
Parameters
1
2
r1compatible
Defaults
None.
Mode
Interface configuration: G3(su)‐>router(Config‐if(Vlan 1))#
Example
This example shows how to set the RIP send version to 2 for packets transmitted on the VLAN 1
interface:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip rip send version 2
16-4 IPv4 Routing Protocol Configuration
Default Distance
0
1
110
120
Specifies RIP version 1. This is the default setting.
Specifies RIP version 2.
Specifies that packets be sent as version 2 packets, but transmits these as
broadcast packets rather than multicast packets so that systems which only
understand RIP version 1 can receive them.