Set Inlinepower Trap; Show Port Inlinepower - Enterasys G3G170-24 Cli Reference Manual

Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the power threshold to 50 on module/unit 1:
G3(su)->set inlinepower threshold 50 1

set inlinepower trap

Use this command to enable or disable the sending of an SNMP trap message for a unit
whenever the status of its ports changes, or whenever the unit's power usage threshold is crossed.
The unit's power usage threshold must be set using the set inlinepower threshold command as
described on page 2‐30.
Syntax
set inlinepower trap {disable | enable} module-number
Parameters
disable | enable
module‐number
Mode
Switch command, read‐write.
Example
This example shows how to enable inline power trap messaging on module 1:
G3(su)->set inlinepower trap enable 1

show port inlinepower

Use this command to display all ports supporting PoE.
Syntax
show port inlinepower [port-string]
Parameters
port‐string
Defaults
If not specified, information for all PoE ports will be displayed.
Disables or enables inline power trap messaging.
Specifies the module on which to disable or enable trap messaging.
(Optional) Displays information for specific PoE port(s).
set inlinepower trap
or module
Enterasys G-Series CLI Reference 2-33