ipv6 nd ra-interval
Usage
When the value of the "other stateful configuration" flag is true, end nodes should use stateful
autoconfiguration (DHCPv6) to obtain additional information (excluding addresses). When the
value is false, end nodes do not. Refer to RFC 2462, "IPv6 Stateless Address Autoconfiguration,"
for more information.
Use the no form of this command to reset the flag to false.
Example
This example sets the other stateful configuration flag to true.
G3(su)->router(Config-if(Vlan 1))# ipv6 nd other-config-flag
ipv6 nd ra-interval
This command sets the transmission interval between router advertisements.
Syntax
ipv6 nd ra-interval sec
no ipv6 nd ra-interval
Parameters
sec
Defaults
600 seconds.
Mode
Router interface configuration: G3(su)‐>router(Config‐if(Vlan 1))#
Usage
The no form of this command resets the interval value to the default of 600 seconds.
Example
This example sets the router advertisement transmission interval to 120 seconds.
G3(su)->router(Config-if(Vlan 1))# ipv6 nd ra-interval 120
ipv6 nd ra-lifetime
This command sets the value, in seconds, that is placed in the Router Lifetime field of router
advertisements sent from this interface.
Syntax
ipv6 nd ra-lifetime sec | 0
no ipv6 nd ra-lifetime
18-16 IPv6 Configuration
Specifies the value in seconds of the router advertisement transmission
interval. The value can range from 4 to 1800 seconds.