Show Config - Enterasys G3G170-24 Cli Reference Manual

Mode
Switch command, read‐only.
Example
This example shows how to display a text file named "mypolicy" in the configs/ directory. Note
that only a portion of the file is shown in this example.
G3(rw)->show file configs/mypolicy
1 :
2 :
3 : #policy
4 :
5 : set policy profile 1 name "Check GUEST" pvid-status enable pvid 4095 untagged-
vlans 1
6 :
7 : set policy profile 2 name "User LABORATORIES" pvid-status enable pvid 680 cos-
status enable cos 4 untagged-vlans 680
8 :
9 : set policy profile 3 name "Administrator" pvid-status enable pvid 4095
10 :
11 : set policy profile 4 name "Guest" pvid-status enable pvid 999 cos-status
enable cos 3 untagged-vlans 999
12 :
13 : set policy port ge.1.1 4
14 :
15 : set policy port ge.1.2 4

show config

Use this command to display the system configuration or write the configuration to a file.
Syntax
show config [all | facility] [outfile {configs/filename}]
Parameters
all
facility
outfile
configs/filename
Defaults
By default, show config will display all non‐default configuration information for all facilities.
Mode
Switch command, read‐only.
(Optional) Displays default and non‐default configuration settings.
(Optional) Specifies the exact name of one facility for which to show
configuration. For example, enter "router" to show only router
configuration.
(Optional) Specifies that the current configuration will be written to a text
file in the configs/ directory.
Specifies a filename in the configs/ directory to display.
Enterasys G-Series CLI Reference 2-45
show config