Defaults
If buckets is not specified, the maximum number of entries maintained will be 50.
If not specified, interval will be set to 30 seconds.
If owner is not specified, monitor will be applied.
Mode
Switch command, read‐write.
Example
This example shows how configure RMON history entry 1 on port
seconds:
G3(rw)->set rmon history 1 ge.2.1 interval 20
clear rmon history
Use this command to delete one or more RMON history entries or reset one or more entries to
default values. For specific values, refer to "set rmon history" on page 12‐6.
Syntax
clear rmon history {index-list | to-defaults}
Parameters
index‐list
to‐defaults
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to delete RMON history entry 1:
G3(rw)->clear rmon history 1
Alarm Group Commands
Purpose
To display, configure, and clear RMON alarm entries and properties.
Specifies one or more history entries to be deleted, causing them to
disappear from any future RMON queries.
Resets all history entries to default values. This will cause entries to
reappear in RMON queries.
clear rmon history
ge
.2.1 to sample every 20
Enterasys G-Series CLI Reference 12-7