Reviewing Port Status; Purpose - Enterasys G3G170-24 Cli Reference Manual

Example
This example shows how to configure port ge.2.1 in the G3G‐24SFP module to operate with a
100BASE‐FX transceiver installed. First, the module is verified as present in Slot 2, and the port
status is shown as operating as a 1000BASE‐SX port. After the 1‐Gigabit transceiver is replaced
with the a 100 Mbps transceiver, the port is configured appropriately and the new settings are
verified.
G3(su)->show version
Slot
----
1
2
3
4
G3(su)->show port advertise ge.2.1
ge.2.1
-------------------------------------------------
10BASE-T
10BASE-TFD
100BASE-TX
100BASE-TXFD
1000BASE-T
1000BASE-TFD
pause
G3(su)->show port status ge.2.1
Port
--------- ------------ ------- ------- --------- ------- ------------
ge.2.1
G3(su)->set port negotiation ge.2.1 disable
G3(su)->set port advertise ge.2.1 100txfd
G3(su)->set port speed ge.2.1 100
G3(su)->set port duplex ge.2.1 full
G3(su)->show port status ge.2.1
Port
--------- ------------ ------- ------- --------- ------- ------------
ge.2.1
For more information, refer to the commands in this chapter and to your G‐Series hardware
installation documentation.

Reviewing Port Status

Purpose

To display operating status, duplex mode, speed, port type, and statistical information about
traffic received and transmitted through one or all switch ports on the device.
Status Ports Model
-------- ----- ----------
Present 24 G3G170-24
Present 24 G3G-24SFP
capability
no
no
no
yes
no
yes
yes
Alias Oper
(truncated) Status
Down
Alias Oper
(truncated) Status
Down
Serial Number
-------------
0011223302
H03611239
advertised remote
no no
no no
no no
no no
no no
yes no
yes no
Admin Speed
Status (bps)
Up N/A
Admin Speed
Status (bps)
Up 100.0M
Reviewing Port Status
Hw Version
--------------
BCM56514 REV 1
BCM56512 REV 1
Duplex Type
N/A 1000BASE-SX
Duplex Type
full 100BASE-FX
Enterasys G-Series CLI Reference 4-3