area virtual-link hello-interval
Example
This example configures a dead interval of 60 seconds for the specified virtual interface.
G3(su)->router(Config-router)# area 20 virtual-link 2.2.2.2 dead-interval 60
area virtual-link hello-interval
This command configures the hello interval for the specified OSPFv3 virtual interface.
Syntax
area areaid virtual-link neighborid hello-interval seconds
no area areaid virtual-link neighborid hello-interval
Parameters
areaid
neighborid
seconds
Defaults
The default hello interval is 10 seconds.
Mode
Router OSPFv3 configuration: G3(su)‐>router(Config‐router)#
Usage
Use the no form of this command to return a configured value to the default value of 10 seconds.
Example
This example configures a hello interval of 30 seconds for the specified OSPFv3 virtual interface.
G3(su)->router(Config-router)# area 20 virtual-link 2.2.2.2 hello-interval 30
area virtual-link retransmit-interval
This command configures the retransmit interval for the specified OSPFv3 virtual interface.
Syntax
area areaid virtual-link neighborid retransmit-interval seconds
no area areaid virtual-link neighborid retransmit-interval
Parameters
areaid
19-18 OSPFv3 Configuration
Specifies the area ID in IP address format (dotted‐quad) or as a decimal
value.
Specifies the virtual link neighbor by means of its router ID. The router
ID must be entered in 32‐bit dotted‐quad notation.
Specifies the value of the hello interval in seconds. The range is from 1
to 65535 seconds.
Specifies the area ID in IP address format (dotted‐quad) or as a decimal
value.