clear port priority-queue
clear port priority-queue
Use this command to reset port priority queue settings back to defaults for one or more ports.
Syntax
clear port priority-queue port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the priority queue settings on
G3(su)->clear port priority-queue ge.2.12
Configuring Quality of Service (QoS)
Purpose
Eight transmit queues are implemented in the switch hardware for each port. The commands in
this section allow you to set the priority mode and weight for each of the available queues (0
through 7) for each physical port on the switch. Priority mode and weight cannot be configured on
LAGs, only on the physical ports that make up the LAG.
Commands
For information about...
show port txq
set port txq
clear port txq
show port txq
Use this command to display QoS transmit queue information for one or more physical ports.
Syntax
show port txq [port-string]
9-6 Port Priority Configuration
Specifies the port for which to clear priority‐to‐queue mappings. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐1.
ge
.2.12:
Refer to page...
9-6
9-7
9-8