Reboot Triggers; Power-Up Reboot; Reload Command From The Cli; Bootrom Monitor Commands Bc And Bw - Enterasys X-Pedition XSR-1805 Getting Started Manual

Verifying uncompressed chksum ...
Starting at 0x10000...
Attached TCP/IP interface to Eth unit 1
Attaching interface lo0...done
cflash:/
Restoring startup configuration files, please wait
Startup configuration files have been restored.
login:

Reboot Triggers

Although there are two types of reboots of the XSR - warm or cold - reboots can be triggered in up
to eight different ways. Refer to the table below.
Table 3-1 Reboot Types
Cause
Power-up
CLI reload
SNMP reload
Watchdog Expiration
Software Crash
Repetitive Software Crash
ROM Monitor
Invalid SW text checksum

Power-Up Reboot

If you power cycle the XSR by flipping the switch on the back panel, the XSR will cold reboot. The
startup-config

Reload Command from the CLI

You can reboot the XSR firmware by issuing the command
prompted to confirm the command. Once the firmware is reloaded, the configuration is loaded
from the startup-config file.

Bootrom Monitor Commands bc and bw

Using Bootrom Monitor mode, you can activate warm or cold reboots by entering
respectively. Refer to
- Volume is OK
Boot Type
Cold
Cold or Warm
Cold or Warm
Warm
Warm
Cold
Cold or Warm
Warm
file stored in Flash becomes the running configuration.
"Bootrom Monitor Mode Commands"
XSR Rebooting Characteristics
reload <cold | warm>
on page 3-58 for more data.
XSR Getting Started Guide 3-57
. You are then
or ,
bw bc