Delta Electronics ASDA-A2 Series User Manual page 206

Call 1(800)985-6929 for Sales
Chapter 7 Motion Control Functions
Attribute of monitoring variables:
Attribute
B
Dn
Dec
Hex
Explanation of monitoring variables:
Monitoring Variables /
Code
000 Feedback position
(00h) (PUU)
001 Position command
(01h) (PUU)
002
Position error (PUU)
(02h)
003 Feedback position
(03h) (pulse)
004 Position command
(04h) (pulse)
005 Position error (pulse)
(05h) B
006 Input frequency of
(06h) pulse command
Feedback speed
007
(07h)
B D1 Dec
Speed input command
008
(Analog)
(08h)
B D2 Dec
009 Speed command
(09h) (Integrated)
Revision January 2011
Call 1(800)985-6929 for Sales
deltaacdrives.com
Basic monitoring variable. Pressing UP/DOWN keys can change the status
shown on LED display.
Decimal place display.
D1 indicates one decimal place,
Decimal display only. When pressing SET key on the keypad, the system
can not switch to hexadecimal display.
Hexadecimal display only. When pressing SET key on the keypad, the
system can not switch to decimal display.
Attribute
Motor feedback – current position. Unit is user unit, PUU.
B
Position command – current position. Unit is user unit,
PUU.
PT mode: it indicates the pulse command received by
the servo drive.
B
PR mode: it indicates the absolute position command.
It is equal to the pulse number sent by the host
(external) controller.
Position error counts between position command pulse
B
and feedback pulse. Unit is user unit, PUU.
Motor feedback – current position. Unit is encoder unit,
B pulse.
Position command – current position. Unit is encoder
unit, pulse.
B
It is also the position command after electronic gear
ratio is set.
Position error counts between position command pulse
and feedback pulse. Unit is encoder unit, pulse.
Input frequency of pulse command received by the servo
drive.
B
Unit is Kpps. Applicable for PT and PR mode.
Actual motor speed. Unit is 0.1r/min.
The low-pass filter function is used so the value is more
stable.
Analog speed input command. Unit is 0.01Volt.
Integrated speed input command. Unit is 1r/min.
The command source may be from analog command /
B
internal parameter / position loop.
deltaacdrives.com
Explanation
D2 indicates two decimal places.
Explanation
sales@deltaacdrives.com
7-3
sales@deltaacdrives.com