Table of Contents
Advertisement
Call 1(800)985-6929 for Sales
2.1 Installation Notes
Please pay close attention on the following installation notes:
Do not bend or strain the connection cables between servo drive and motor.
When mounting the servo drive, make sure to tighten all screws to secure the drive in
place.
If the servo motor shaft is coupled directly to a rotating device ensure that the alignment
specifications of the servo motor, coupling, and device are followed. Failure to do so may
cause unnecessary loads or premature failure to the servo motor.
If the length of cable connected between servo drive and motor is more than 20m, please
increase the wire gauge of the encoder cable and motor connection cable (connected to U,
V, W terminals).
Make sure to tighten the screws for securing motor.
2.2 Storage Conditions
The product should be kept in the shipping carton before installation. In order to retain the
warranty coverage, the AC servo drive should be stored properly when it is not to be used for
an extended period of time. Some storage suggestions are:
Store in a clean and dry location free from direct sunlight.
Store within an ambient temperature range of -20°C to +65°C (-4°F to 149°F).
Store within a relative humidity range of 0% to 90% and non-condensing.
Do not store in a place subjected to corrosive gases and liquids.
Correctly packaged and placed on a solid surface.
Revision January 2011
Call 1(800)985-6929 for Sales
deltaacdrives.com
Chapter 2 Installation and Storage
deltaacdrives.com
sales@deltaacdrives.com
2-1
sales@deltaacdrives.com
Advertisement
Table of Contents
