Delta Electronics ASDA-A2 Series User Manual page 136

Call 1(800)985-6929 for Sales
NOTE
1) When bit0 of P2-33 is set to 1, it indicates that the system inertia estimation of semi-auto
mode has been completed and the measured load inertia value is saved and memorized in P1-
37 automatically.
2) If reset bit0 of P2-33 to 0, it will start estimating the system inertia again.
Revision January 2011
Call 1(800)985-6929 for Sales
deltaacdrives.com
Chapter 5 Trial Run and Tuning Procedure
deltaacdrives.com
sales@deltaacdrives.com
5-19
sales@deltaacdrives.com