Appendix 6 Parameter Setting Checklist; Appendix 6.1 Parameter Setting Checklist - Mitsubishi MELSEC-Q Series User Manual

APPENDIX

Appendix 6 Parameter Setting Checklist

Appendix 6.1 Parameter setting checklist

Item
Start I/O No.
Operational settings
Type
Mode
All connect count
Remote input (RX)
Remote output (RY)
Remote register (RWr)
Remote register (RWw)
Special relay (SB)
Special register (SW)
Retry count
Automatic reconnection station
count
Standby master station No.
PLC down select
Scan mode setting
Delay information settings
App - 41
This checklist may be used to set the parameters required to configure a CC-Link
system.
Please make a copy of this checklist and use it as needed.
For setting details, see Section 6.3.
Parameter setting checklist
Setting range
0000 to 0FF0
Input data hold/clear
Default: Clear
Master station
Master station (Duplex function)
Local station
Standby master station
Default: Master station
Online (Remote net mode)
Online (Remote I/O net mode)
Offline
Default: Online (Remote net mode)
1 to 64
Default: 64
Device name: Select from X, M, L, B, D, W, R or ZR
Device name: Select from Y, M, L, B, T, C, ST, D, W, R or ZR
Device name: Select from M, L, B, D, W, R or ZR
Device name: Select from M, L, B, T, C, ST, D, W, R or ZR
Device name: Select from M, L, B, D, W, R, SB or ZR
Device name: Select from M, L, B, D, W, R, SW or ZR
1 to 7
Default: 3
1 to 10
Default: 1
Blank, 1 to 64 (Blank: No standby master station specified)
Default: Blank
Stop/continue
Default: Stop
Asynchronous/synchronous
Default: Asynchronous
0 to 100 (0: Not specified)
Default: 0
MELSEC-Q
Setting value
Hold/clear
Master station
Master station (Duplex function)
Local station
Standby master station
Online (Remote net mode)
Online (Remote I/O net mode)
Offline
modules
times
modules
Stop/continue
Asynchronous/synchronous
App - 41