Mitsubishi MELSEC-Q Series User Manual page 4

[WIRING PRECAUTIONS]
•
When turning on the power and operating the module after installing is completed, always attach
the terminal cover that comes with the product.
There is a risk of malfunction if the terminal cover is not attached.
•
Tighten the terminal screws within the range of specified torque.
If the terminal screws are loose, it may cause short circuits, or malfunction.
If the terminal screws are tightened too much, it may cause damage to the screw and/or the
module, resulting in fallout, short circuits or malfunction.
•
Be careful not to let foreign matters such as sawdust or wire chips get inside the module.
These may cause fires, failure or malfunction.
•
The top surface of the module is covered with protective film to prevent foreign objects such as
cable offcuts from entering the module when wiring.
Do not remove this film until the wiring is complete.
Before operating the system, be sure to remove the film to provide adequate heat ventilation.
•
Use a dedicated cable as specified by the manufacturer for the CC-Link system. If a cable other
than the one specified by the manufacturer is used, the performance of the CC-Link system
cannot be guaranteed. Also, follow the specifications listed in Chapter 3 for the overall cable
distance and the station-to-station cable length. If wiring is done other than as specified,
accurate transmission of data cannot be guaranteed.
•
Be sure to fix communication cables or power supply cables leading from the module by placing
them in the duct or clamping them.
Cables not placed in the duct or without clamping may hang or shift, allowing them to be
accidentally pulled, which may cause a module malfunction and cable damage.
•
When removing the communication cable or power supply cable from the module, do not pull the
cable. When removing the cable with a connector, hold the connector on the side that is
connected to the module.
When removing the cable connected to the terminal block, first loosen the screws on the part
that is connected to the terminal block.
Pulling the cable that is still connected to the module may cause malfunction or damage to the
module or cable.
A - 3
CAUTION
!
A - 3