Initial Setting Of The Remote Device Station; Setting The Target Station Number; Setting The Regist Procedure Registration - Mitsubishi MELSEC-Q Series User Manual

10 COMMUNICATION BETWEEN THE MASTER STATION AND REMOTE
DEVICE STATIONS

10.3 Initial Setting of the Remote Device Station

10.3.1 Setting the target station number

10.3.2 Setting the regist procedure registration

10 - 7
This section explains the initial setting of the remote device station.
Set the target station for which the initial setting is performed.
(1) Setting the target station number
Set the target to "1".
(2) Selecting the Regist procedure
Click the "Regist procedure" of the target station number "1".
Set the conditions and details of the remote device station settings.
In this section, AJ65BT-64AD is used as an example for the Regist procedure
registration.
The details to be set are as follows:
Select Current from Voltage/Current (the first condition).
Select the Factory setting of the Offset/gain value (the second condition).
Set Average number of times for channel 2 to 50 times (the third condition).
Set Average time for channel 3 to 100 ms (the fourth condition).
Specify Average processing setting for channels 2 and 3, Number of times for
channel 2 and Time for channel 3 (the fifth condition).
Set the data format from -2000 to 2000 (the sixth condition).
Set channels 1 to 3 to A-D conversion enable (the seventh condition).
Turn the Initial data processing completed flag to ON (the eighth condition).
Turn the Initial data setting request flag to ON (the ninth condition).
Turn the Initial data processing completed flag to OFF (the tenth condition).
Turn the Initial data setting request flag to OFF (the eleventh condition).
For more detailed information about the settings, see the Remote Device Station
User's Manual.
(1) Setting the first condition
(a) Execute Flag setting
Set the "Execute Flag" to "Execute".
(b) Operational condition setting
Set the "Operational condition" to "Set new".
MELSEC-Q
10 - 7