Procedure Before Starting The Data Link - Mitsubishi MELSEC-Q Series User Manual

7 PROCEDURE BEFORE STARTING THE DATA LINK

7 PROCEDURE BEFORE STARTING THE DATA LINK
7.1 Procedure Before Starting the Data Link
7
When performing
parameter setting with
GX Developer
Set the parameters with the GX Developer
(see Section 6.3).
Network parameters
(see sections 6.3.1 and 6.3.3)
Automatic refresh parameters
(see sections 6.3.2 and 6.3.4)
7 - 1
This chapter explains the procedure from the module installation to the data link startup.
The following describes the procedure from the module installation to the CC-Link data
link startup.
Mount the master module, local module and
standby master module on the base unit.
Mount the remote modules on the control board
and machine.
Check the master module, local module and
standby master module individually to see if
they operate normally (hardware test).
Connect the modules with the CC-Link dedicated
cable. Connect a terminal resistor that matches
the cable type to the modules located at both ends.
Check items prior to turning power ON:
Check the module installation status
Check the input power voltage
Verify that the CPU RUN/STOP switch is set to
"STOP"
Verify that the CPU RESET switch is set to the
"middle position"
Set the switches on the master module, local
module and standby master module
(see Sections 7.3 and 7.7).
Station number setting (see Section 7.7.1)
Transmission rate, mode setting
(see Section 7.7.2)
Turn the power ON
To the next page
Start
· · · · · · · See Section 7.4.
· · · · · · · See Section 7.5.
Set the PLC parameter with the GX Developer.
(see Section 6.4)
Create a program in which the RLPASET
instruction is used.
(see Section 6.4)
To the next page
MELSEC-Q
When performing
parameter setting with
dedicated instruction
7 - 1