Roland R1000 Series Manual page 87

B0046191 / Rev. 1.12
6.3.6 Clear 2-sheet / Clear 0-, 1- , 2-sheet outputs
( CLR 2-sheet, 0-sheet, 1-sheet, 2-sheet)
(Warning, 0-sheet, 1-sheet, 2-sheet)
( Warning, 0-sheet, 1-sheet, 2-sheet)
Fig. 47: Timing diagram for clear sheet outputs
6.3.7 Teach-In 0-sheet / Zero adjust
Teach-In 0-sheet,Zero adjust
BIN 10.6 to 10.7
Sensor selection A/B
BOUT 10.6 to 10.7
Sensor selection A/B
Function result
Function fault
Fig. 48: Timing diagram for Teach-In / zero adjust
1)
In case of "Function fault" = 1 "Function result" will sometimes remain at 0.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector R1000 series E20
with integrated fieldbus interface
BIN 8.5
BOUT 8.0
1)
Function result
BOUT 8.2
Function fault
BOUT 8.3
Ready
BOUT 8.4 to 8.7
OUT
Note The measured timing periods were determined with 12 Mbit- Profibus.
These timing periods can vary with different transmission rates and bus
systems. The cycle time of the PLC has not been taken into account.
BIN 8.2
BOUT 8.0
1)
BOUT 8.2
BOUT 8.3
Ready
Note The measured timing periods were determined with 12 Mbit- Profibus.
These timing periods can vary with different transmission rates and bus
systems. The cycle time of the PLC has not been taken into account.
Note According to the setting in the configuration menu, item 12 "Sensor
selection" the Zero adjust causes following:
- external: the selected sensor in "selection A/B" is nulled.
- Program: the selected sensors in the active program are nulled.
Manual
„1" if fault
0V if fault
„0" active
„0" active
< 10ms < 10ms < 10ms
„1" if fault
0V if fault
< 10ms
Communication with the PLC
87