Roland R1000 Series Manual page 55

B0046191 / Rev. 1.12
4.3.6 Spring loaded sensor bracket SHS42G-FB (with bellow suction cup)
The spring loaded sensor bracket SHS42G-FB with bellow suction cup is intended for the
installation of the P sensor. It is well suitable for use in robotic destackers, since transversal forces
(appearing on fast turning motions) are well compensated.
The suction vacuum and the integrated nap ring assure a full-area pressure contact of sensor and
sheet.
The suction cup has a Shore hardness of 45 (red), harder suction cups with a Shore hardness of
60 (black) are available (see chapter 12 „Order data - sensors and accessories).
On installing, attention must be paid that the sensor is thoroughly sealed (e.g. with Teflon tape) in
the thread seating.
Considerations:
• The sensor face must align with the naps.
•
The vacuum must adequately effect.
•
The suction facility must be kept free from loading, i.e. the springs may only be low pre-
tensioned.
•
The suction facility must not be used as load-lifting device.
60,5
39,5
Fig. 31: Sensor bracket SHS42G-FB
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector R1000 series E20
with integrated fieldbus interface
38
65,5
A-A ( 1 : 2 )
20
Manual
enclosed:
swingable angular connection
for hose
inner Ø6mm, outerØ8 mm
1
2
3
Mounting
110
50
: unloaded 128 ± 1
: unloaded 90 ± 1
: Spring travel: appr. 37
55