Roland R1000 Series Manual page 104

Communication with the PLC
6.6.6 CPS file for CC-Link
The CSP file contains the specific configuration data of the device. The data must be known to the
controller.
The manufacturers of the controller supply the tools for the integration of the CSP file into the
network. Roland Electronic does not supply such tools, because they have to be compatible with
the interface design of the controller.
The CSP file is supplied on a CD or can be downloaded from the Roland homepage.
Three „occupied Stations" with 36 Byte are used. 12 Byte are Bit Data Area and 24 Byte Word Data
Area.
Link Input (Roland R1000 => PLC)
W0 W1 W2 W3 W4 W5
Bit Data area
word 0 to 4 (Byte 0-9)
not used
Link Output (PLC => Roland R1000)
W0 W1 W2 W3 W4 W5
Bit Data area
word 0 to 4 (Byte 0-9)
not used
*1) Remote Ready: after Roland R1000 is ready for Data exchange the signal Remote READY is
set. If Remote READY is off the Data are not valid.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
104
Double Sheet Detector R1000 series E20
with integrated fieldbus interface
W6 W7 W8
System area Word Data area
word 5 word 0 to 3
Bit 3 = Roland I20
Remote Parameter channel
Ready *1) (see Chapter 6.2)
W6 W7 W8
System area Word Data area
word 5 word 0 to 3
not used Roland I20
Parameter channel
(see Chapter 6.2)
Manual
W9 W10 W11 W12 W13
Word Data area
word 4 to 11
Roland I20 Process channel (see Chapter 6.2)
W9 W10 W11 W12 W13
Word Data area
word 4 to 11
Roland I20 Process channel (see Chapter 6.2)
B0046191 / Rev. 1.12
W14 W15 W16 W17
W14 W15 W16 W17