Omron SYSMAC CVM1-PRO01-V1 Operation Manual page 41

Changing the Display Language (English/Japanese)
C200H-MC221
7. Press either "1" or "2."
Note Once the connections have been completed, setting of the connected device
can be performed using the following operations when changing the display lan-
guage between English and Japanese:
• Turning ON the power supply for the PC while pressing the CLR Key.
• Connecting the Teaching Box while pressing the CLR Key.
The setting of pin 2 will be checked and become valid only when the power to the
PC is turned ON.
To display messages in Japanese on the Teaching Box, set pin 2 of the DIP
switch on the MC Unit's rear panel to OFF.
The default setting is ON (English.)
The remaining procedure is the same as that for the CV500-MC221/421.
Note Once the connections have been completed, setting of the connected device
can be performed using the following operations when changing the display lan-
guage between English and Japanese:
• Turning ON the power supply for the PC while pressing the CLR Key.
• Connecting the Teaching Box while pressing the CLR Key.
The setting of pin 2 will be checked and become valid only when the power to the
PC is turned ON.
Section
DIP switch
ON
3-4
29