Switching The Message Display (Cs1W-Mc221/421 Only) - Omron SYSMAC CVM1-PRO01-V1 Operation Manual

Switching the Message Display (CS1W-MC221/421 Only)

Procedure
1, 2, 3...
7-7

Switching the Message Display (CS1W-MC221/421 Only)

Caution
!
Procedure
1, 2, 3...
Use the following procedure to perform origin setting for an absolute encoder.
Note After completion of ABS origin setting, as a safety precaution, perform backup
for the system parameters using CX-Motion.
1. Select "5. ABS SETTING," from the EXTENSION mode menu.
EXT| ABS SET
| 0.ALL AXES
| 1.X
5
| 2.Y
2. Select the axis or axes for which servo-unlock is to be executed.
In this example, all axes are selected.
EXT| ABS SET
| OK?
ALL|
0
| YES / NO
Indicates selected axes as follows:
ALL: All axes; X: X axis; Y: Y axis; Z: Z axis; U: U axis
3. Press the YES Key to perform origin setting.
The absolute encoder values will be written into the system parameters.
When the operation has been completed, the following display will appear.
EXT| ABS SET
|
ALL| COMPLETE!
YES
|
This display will appear even if origin setting is accidentally performed for an
axis not using an absolute encoder. In this case, however, the absolute en-
coder values will not be written into the system parameters.
Note When using the CS1W-MC221/421, the absolute position settings
will be stored in the internal memory. For this reason, if the power sup-
ply for the MC Unit is turned OFF, the absolute position settings will
return to the original values. Save the parameters by writing them to
flash memory.
This operation is used to switch the message display for the Teaching Box be-
tween English and Japanese.
The factory setting is for English display.
After selecting "MC Series" as the connected device, press the CLR Key to dis-
play the online connections initialization screen, and make the setting in EX-
TENSION mode.
Do not change the display language while the program is being executed or
while a motor is moving. Unexpected operation can result.
Use the following procedure to switch the language for the message display.
1. Select "6. LANGUAGE," from the EXTENSION mode menu.
3.Z
4.U
EXT| LANGUAGE
| JAPANESE
|
| SWITCH:↑,↓
Section 7-7
69