Omron SYSMAC CVM1-PRO01-V1 Operation Manual page 35

Connecting to the MC Unit
Connecting to the MC Unit
1, 2, 3...
CS1W-MC421
1. Remove the connector cover.
Open the cover using a
Cover
small-size flat-blade
screwdriver.
2. Plug the connecting cable's connector into the Teaching Box's connector.
3. Insert the connecting cable's connector into the MC Unit's peripheral con-
nector. For the CS1W-MC221/421 and CV500-MC221/421, "T.B" is written
on the connector and for the C200H-MC221, "TOOL" is written on the con-
nector. The location of the peripheral connector on each of the MC Units is
shown below.
For the C200H-MC221, connect the connector and then set the tool selec-
tion switch to "T.B."
CV500-MC421
CS1W-MC221
Attach the removed cover to the
rear surface so as not to lose it.
Cover attached
Align the connector and push it in until
you hear a click.
CV500-MC221
C200H-MC221
Section 3-1
Tool selection
switch
23