Throttle Control Cable/ Throttle Link - Honda BF135A Manual

12. THROTTLE CONTROL CABLE/
THROTTLE LINK
Inspection:
1) Remove the engine cover (P. 4-2).
Remove the front separate cover (P. 4-7).
2) Move the remote control lever to the "F" (Forward) full
open position.
NOTICE
• If it is hard to move the remote control lever to the "F"
(Forward) position with the engine stopped, move the
lever while turning the propeller or propeller shaft.
• Do not move the remote control lever with force, or
damage to the gearshift system can result.
3) With the remote control lever in the "F" (Forward) full open
position, check that the throttle arm is in contact with the
full open stopper of the shift link bracket.
4) With the throttle arm in the position described in step 3,
check for clearance between the throttle cam of the throttle
body and the full open side stopper. It must be 1 mm (0.04
in) or below.
5) Move the remote control lever to the "N" (Neutral) position
and check that the throttle cam of the throttle body is in the
full close position.
Check the clearance between the throttle cam and the full
close side stopper. It must be 1 mm (0.04 in) or below.
6) If either of the above step 3, 4 or 5 is not satisfied, adjust as
follows (P. 3-27).
If step 3 is not satisfied: Go to <Throttle arm not in full open
position>.
If step 4 or 5 is not satisfied: Go to <Throttle cam not in full
open position>.
3-26
[3] "F" (FORWARD)
[2]
REMOTE
CONTROL
LEVER
[1]
FULL
OPEN
POSITION
[1] THROTTLE ARM
[3]
FULL OPEN
STOPPER
[1] THROTTLE
CAM
[3] 1 mm (0.04 in) OR BELOW
[1]
THROTTLE
CAM
[2] 1 mm (0.04 in) OR BELOW
[4] "N" (NEUTRAL)
[2] SHIFT LINK
BRACKET
[2]
STOPPER
(FULL
OPEN
SIDE)
[3]
STOPPER
(FULL
CLOSE
SIDE)