Honda BF135A Manual page 438

4) Align the alignment mark on the front balancer holder with
the projection on the rear balancer shaft.
5) Hold the rear balancer shaft by inserting the special tool
into the maintenance hole in the front balancer.
TOOL:
Pin driver, 6.0 mm
NOTICE
Check that the special tool is inserted in the balancer case
assembly securely.
6) Install the balancer chain on the crankshaft sprocket while
aligning the " " mark on the crankshaft sprocket with the
color plate (1 place) of the balancer chain.
7) Install the driven sprocket on the balancer chain while
aligning the alignment mark on the driven sprocket with
the color plates (2 places) of the balancer chain.
12-9
[1]
REAR BALANCER
SHAFT
[1]
PIN DRIVER, 6.0 mm
07744-0010500
07744-0010500
[3]
REAR BALANCER SHAFT
[1]
CRANKSHAFT
SPROCKET
[4]
COLOR PLATE (1 place)
[4]
ALIGNMENT
MARK
[3]
BALANCER
CHAIN
[2] [3]
PROJECTION ALIGNMENT
MARK
[2] MAINTENANCE
HOLE
[2]
BALANCER
CHAIN
[3] " " MARK
[1]
COLOR PLATE
(2 places)
[2]
DRIVEN
SPROCKET