Honda BF135A Manual page 480

5) Install the shift rod by aligning the shift cam of the shift rod
with the groove in the shift slider so that the cutout of the
shift rod spline faces in the cruising direction.
NOTICE
• Check that there is no marking in the shift rod end.
• If the shift cam is in alignment with the groove in the shift
slider but the cutout of the spline is not in the cruising
direction, see the step 3 on page 14-5 and adjust
accordingly.
[1]
<LC, XC, LD and XD types>
[2]
[3] NO MARK
SHIFT ROD
6) Apply grease to the circumference of the new 55.6 x 3.5
mm O-ring and install it on the shift rod holder.
7) Install the shift rod holder aligning the projection with the
concave in the gear case and tighten with the pivot washer
and the 6 x 12 mm hex. bolt.
After installation, check that the cutout of the shift rod
spline faces in the cruising direction.
14-13
[4]
<XCC, LCD and XCD types>
[5]
MARK
[3]
SHIFT ROD
[1] CUTOUT
[4]
CRUISING
DIRECTION
[3]
SHIFT ROD
[1]
55.6 x 3.5 mm
O-RING
[1]
SHIFT ROD
HOLDER
[2] No mark in the shift
rod end.
[3]
SHIFT ROD
[5]
SHIFT CAM
[6]
GROOVE IN SHIFT
SLIDER
[2] SHIFT ROD
HOLDER
[2] PROJECTION
[3] 6 x 12 mm
HEX. BOLT
[4] PIVOT
WASHER
[5]
CONCAVE