Starter Cable - Honda BF135A Manual

2. STARTER CABLE

a. REMOVAL
Remove the following parts.
– Engine cover (P. 4-2)
– Front separate cover (P. 4-7)
NOTICE
Disconnect the starter cable from the battery before
disconnecting and connecting the starter cable.
1) Release the starter cable from the two harness clips.
2) Release the starter cable 1P connector (White wire) from
the connector bracket C.
3) Disconnect the starter cable 1P connector (White wire).
4) Remove and disconnect the two 8 mm washer-nuts,
alternator fuse cable, 8 mm washer and the positive (+)
starter cable from the magnetic switch B terminal.
5) Remove the 8 x 18 mm flange bolt from the crankcase, then
disconnect the negative (–) starter cable.
6) Remove the harness band clip that secures the starter cable
from the cable bracket B.
Remove the wire harness clip.
18-15
[4] HARNESS
CLIP (2)
[1] 8 mm WASHER-
NUT (2)
[2] ALTERNATOR
FUSE CABLE
[3] 8 mm WASHER
[4]
STARTER
CABLE (+)
[1] CABLE BRACKET B
[3]
[4]
WIRE HARNESS CLIP
HARNESS
BAND CLIP
[1]
STARTER
CABLE 1P
CONNECTOR
(W WIRE)
[2]
CONNECTOR
BRACKET C
[3]
STARTER CABLE
[5]
B TERMINAL
[2]
STARTER
CABLE (–)
8 x 18