Honda BF135A Manual page 151

6) Check that the taped ends of the power tilt motor wire and
trim angle sensor wire are in alignment with the end of the
undercase grommet C. Install the undercase grommet C on
the under cover front bracket so they engage securely in
the groove of the undercase grommet C.
Move the front lock with a hand and check that the wires
and tube do not interfere with the front lock.
7) Adjust the length between the end of the cable outer and
the end of the nut of the cover lock cable A (longer one) so
that it is 20 mm (0.8 in) as shown.
8) Holding the nut in the position described in step 7, position
the inner cable end of the cover lock cable A on the front
lock and position the cable A nut on the under cover front
bracket.
Tighten the washer side lock nut securely.
• Check that the nut set in step 7 is not out of the position.
If it is, repeat the procedure from step 7.
9) Position the 4 x 7 x 160 mm vinyl tube and the 3.5 x 430 mm
fuel tube on the under cover front bracket.
4-32
[2]
Wires and tube must not
interfere with the lock lever.
[1]
FRONT
LOCK
[7]
UNDERCASE
GROMMET C
[6]
SPEED
SENSOR
TUBE A [5] TRIM ANGLE
SENSOR WIRE
20 mm (0.8 in)
[1]
UNDER COVER
FRONT
BRACKET SIDE
[2]
4 x 7 x 160 mm
VINYL TUBE
[6] FRONT LOCK
[3] TAPED PART
[4]
POWER
TILT
MOTOR
WIRE
[3] COVER LOCK
CABLE A
[4]
LOCK
NUT
[5]
3.5 x 430 mm
FUEL TUBE