Honda BF135A Manual page 531

6) Apply gear oil to the circumference of the new 105 x 3.1
mm O-ring and install it on the propeller shaft holder.
7) Install the new thrust shim on the propeller shaft holder.
8) Install the thrust bearing washer with the chamfered side
toward the thrust shim.
9) Apply gear oil to the circumference of the thrust bearing
and install it on the thrust bearing washer.
10) Check that there is the groove at the spline of the propeller
installation side of the propeller shaft.
[1]
<LC, XC, LD and XD types>
[2] No groove
[3]
PROPELLER SHAFT
11) Install the propeller shaft and the thrust bearing washer on
the propeller shaft holder.
Install the thrust bearing washer with the chamfered side
toward the flange of the propeller shaft.
12) Install the new shim on the bearing holder.
13) Apply gear oil to the circumference of the taper bearing
(outer race) and install it on the bearing holder.
NOTICE
Install the taper bearing (outer race) with the smaller
diameter side toward the shim.
14) Install the taper bearing (outer race) on the bearing holder
using the special tools and the hydraulic press as shown.
TOOLS:
Driver
Taper bearing inataller attachment
14-64
[4]
<XCC, LCD and XCD types>
[5] Groove
[3]
PROPELLER SHAFT
07749-0010000
070PF-ZY60100
[1]
CHAMFER
[6]
THRUST SHIM
[5]
105 x 3.1 mm
O-RING
[2] THRUST BEARING
WASHER
[1]
PROPELLER
SHAFT HOLDER
[4]
PROPELLER SHAFT
[1]
FORWARD BEVEL
GEAR SHIM
[3]
BEARING
HOLDER
[1]
DRIVER
07749-0010000
[4]
50 x 90 x 28 mm
TAPER BEARING
(OUTER RACE)
[2]
THRUST
BEARING
[3]
THRUST BEARING
WASHER
[4] PROPELLER
SHAFT HOLDER
[3]
CHAMFER
[2]
50 x 90 x 28 mm
TAPER BEARING
(OUTER RACE)
[2]
TAPER BEARING
INSTALLER
ATTACHMENT
070PF-ZY60100
[3]
BEARING
HOLDER