Honda BF135A Manual page 332

15) Tighten the two 4 x 25 mm screw-washers and the two 4 x
6 mm screws securely while pushing the brush of the IC
regulator/brush holder assembly, assembled in step 14,
lightly against the rotor shaft slip rings.
Tighten the 4 x 6 mm screw securely that has been
tightened loosely in step 14.
NOTICE
Take care not to damage the rotor shaft slip rings with the
brush during installation.
16) Install the rear end cover and tighten the three rear end
cover bolts securely.
17) Install the insulator bushing and tighten the 6 mm hex. nut
securely.
6-21
[1] 4 x 6 mm SCREW (2)
[3]
IC REGULATOR/BRUSH
HOLDER ASSEMBLY
[4]
SLIP
RINGS
[1] REAR END
COVER
BOLT (3)
[2] REAR END
COVER
[3]
INSULATOR
BUSHING
[4]
6 mm HEX. NUT
[2]
4 x 25 mm SCREW-
WASHER (2)