Honda BF135A Manual page 427

3. FLYWHEEL
a. REMOVAL
1) Remove the engine from the outboard motor (P. 7-2).
2) Remove the oil pump body assembly (P. 11-6).
3) Set the special tool on the starter motor mounting part and
temporarily tighten the special tool using the 10 mm bolts,
10 mm washers and the 10 mm nuts.
NOTICE
• Do not damage the mating surface of the oil pump body
gasket on the cylinder block.
• Check that the special tool is set on the ring gear securely.
TOOL:
Ring gear holder
4) Remove the eight 8 mm special bolts and the flywheel
boss.
5) Remove the eight 12 mm bolts and the flywheel.
6) Remove the special tool.
11-12
[3]
10 mm NUT (2)
070PB-ZY60100
[1]
FLYWHEEL BOSS
[2]
8 mm SPECIAL
BOLT (8)
[1]
12 mm BOLT (8)
[1]
10 mm BOLT (2)
[2]
RING GEAR HOLDER
070PB-ZY60100
[2]
FLYWHEEL