Troubleshooting With Hds Tester - Honda BF135A Manual

6. TROUBLESHOOTING WITH HDS
TESTER
• DTC (DIAGNOSTIC TROUBLE CODE) CHECK
1. Remove the engine cover and the electric part cover
(Section 4).
2. Disconnect the 4P (Red) connector and connect the
HDS pocket tester to the data link connector (DLC).
4P CONNECTOR
(RED)
TESTER WIRE
HDS POCKET
TESTER
3. Turn the ignition switch ON and check the DTC shown
on the HDS pocket tester.
Refer to the HDS pocket tester's operation manual for
how to use the HDS pocket tester.
5-13
DATA LINK
CONNECTOR (DLC)
• WHEN USING HDS POCKET TESTER DURING
CRUISING
1. Remove the engine cover and the electric part cover
(Section 4).
2. Remove the cap from the under cover front bracket.
Route the extension wire in the HDS pocket tester kit
through the front cover bracket.
• Set the grommet on the under cover front bracket
securely.
UNDER COVER
FRONT BRACKET
CAP
3. Disconnect the red 4P connector from the DLC (Data
Link Connector) and secure the DLC wire as sown.
• Route the extension wire of the tester in the position
shown so that it does not interfere with the parts.
4. Connect the extension wire to the DLC.
CLAMP
EXTENSION WIRE
OF TESTER
BF135A•BF150A
DLC