Throttle Cable Adjustment - Honda BF2D Series Manual

3) With the engine idling, turn the pilot screw in or out to
the setting that produces the highest idle speed.
The correct setting will usually be obtained at approxi-
mately the following number of turns out from the fully
closed (lightly seated) position.
Standard pilot
screw opening
SCG, LCG, SCHG, LCHG type:
2-1/4 turns out
Except SCG, LCG, SCHG, LCHG
type:
2 turns out
4) After the pilot screw is correctly adjusted, turn the throt-
tle stop screw to obtain the standard idle speed.
Specified idle
speed in neutral
2,000
±
100 min-' (rpm)
7. THROTTLE CABLE
(SH, SCH, LH, LCH
type)
Adjustment:
1) Check the throttle grip play.
The play must be approximately one graduation from the
throttle mark.
2) If adjustment is necessary, adjust by loosening the lock
nut and turning the adjusting nut right or left.
3) Move the throttle grip to the full open position and check
whether the throttle arm contacts the stopper.
If the throttle arm does not contact the stopper, repeat
the above steps 1) and 2).
4) Check whether the throttle grip moves smoothly and it is
linked with the carburetor throttle lever operation. Check
to see whether the carburetor throttle lever operates
smoothly from the fully close to the full open positions.
If the carburetor throttle valve does not open or close
fully, check the throttle wire installation and adjust as
needed.
[1]
PILOT SCREW WITH
LIMITER CAP
:HON'D.A
BFeD
-------------------
[1] THROTTLE STOP SCREW
[2] THROTTLE GRIP
[3] LOCK NUT
[7]
THROTTLE WIRE
[6]
THROTTLE VALVE
[5] THROTTLE ARM
3-6
Page: 26 - Honda BF2D Outboard Motors Shop Manual - http://www.ReadManuals.Com